The Stand works by: Lifting up the top rail and inserting into the centre the rear pole, this has a special clip that makes lifting the sign from the base easy. Then, lift the sign all the way to the top. The spring inside the base keeps tension. Then, when fully extended. Insert the pole into the hole position. The banner stand will rewind to keep the graphic taut. Changing the graphic is easy. No need to buy more stands, you can replace with a new print. Special tape is on the lower fitting panel that can be reused.
High quality printing on long lasting Ultra Smooth Banner Material purchased specifically for Banner Stands.
We do not use cheap paper or laminated poly, this stand is fitted with extra strong banner sign material, printed in high quality, 2 pass printing to give your graphic ultra vibrant colours. Great graphics and resolution.
Printed with Solvent (alcohol) based inks, the Yellows, Magenta's will not fade in sunlight.
Achieves Blue wool scale 4.
Advantages: Using Vinyl Banner material will not crack, peel or suffer typical 'crododile creases' as typically seen using cheap laminated paper or poly paper alternatives. We only use outdoor graded materials. These banner stands are designed for constant use, portability and durability.
Changing any graphics at a later stage: We use special 3M double sided tape to secure the printed sign onto the banner stands, at any stage you can easily remove the graphic to replace/renew your graphic image. Additional covering tape (white) is used to protect the seal and overlaps. The banner stand includes a locking pin that allows easy change over of graphics. To replace any sign panel, undo the hand screw from underneath, insert the supplied pin to prevent the panel retracting, remove the existing artwork, and replace with the new skin. Very Easy.
Rear Pole: Finished Silver to match the stand.
Extra strong rear pole with elastic, we specify a stronger rear metal pole (16.6mm diameter with a .9mm wall, this means better tension and smoother upright banner stand position). The rear pole is also powdercoated to match the banner stand.
Top rail: Finished Silver to match the stand.
The top rail is also extra strong, double channel powdercoated to match the banner stand. Also uses special 3M double sided tape to secure the banner, the back side is also secured with grub screws for additional strength, this gives greater overall tension without flapping. The top rail is very strong and will not bow. The extra strength keeps your image taut.
Actual printing: This image shows the high print resolution achieved, all banner stand prints are twin pass digital using 8 dot digital print technology. Printed in digital CMYK. Call our graphic designers for file setup info if required.